Video 43• In mode, you can also set [Zoom Speed] to one of threeconstant speeds (3 is the fastest, 1 the slowest).• When [Zoom Speed] is set to [ Variable], the zoom speed will befaster in record pause mode than when actually recording, except whenpre-recording ( 59) is activated.Quick Start FunctionWhen you close the LCD panel with the camcorder on, the camcorderenters the standby mode. In standby mode the camcorder consumesonly about 1/3 the power used when recording, saving energy whenyou are using a battery pack. Additionally, when you open the LCDpanel, the camcorder is ready to start recording in approximately1 second*, allowing you to record the subject right away.* The actual time required varies depending on the shooting conditions.1 With the camcorder on and in a recording mode, close the LCDpanel.A beep will sound and the green ON/OFF (CHG) indicator will changeto orange to indicate the camcorder entered standby mode.2 When you wish to resume recording, open the LCD panel.The ON/OFF (CHG) indicator turns back green and the camcorder isready to record.IMPORTANT• Do not disconnect the power source during standby mode (while theON/OFF (CHG) indicator is lit in orange).NOTES• The camcorder will not enter standby mode if the LCD panel is closedwhile the ACCESS indicator is on or flashing, while a menu is being dis-played, or while the PHOTO button is pressed down halfway. The cam-corder may also not enter standby mode if the LCD panel is closedwhile the memory card slot cover is open or when the battery charge istoo low. Check that the ON/OFF (CHG) indicator changes to orange.Operating modes:COPYDownloaded From VideoCamera-Manual.com Manuals
