Canon Super G3 Fax Board-AF1 Service Manual

Canon Super G3 Fax Board-AF1 Service Manual Manual pdf 46 page image

Chapter 55-45.2.4 SSSW-SW045.2.4.1 Detailed Discussions of Bit 2 0025-3097Use it to select the number of last flag sequences for a protocol signal (transmission speed at 300 bps). Select '2' if the other party fails to receive the protocol signalproperly.5.2.4.2 Detailed Discussions of Bit 3 0025-3098Use it to select an appropriate reception mode after transmission of the CFR signal.If errors occur frequently at time of reception because of the condition of the line, select 'high speed' for reception mode and, at the same time, selects 'do not receive'for 'ECM reception.'5.2.4.3 Detailed Discussions of Bit 4 0025-3099Use it to select the time length during which low-speed signals are ignored after transmission of the CFR signal.If the condition of the line is not good and, therefore, the reception of image signals is difficult, select '1500 ms.'5.2.5 SSSW-SW055.2.5.1 Functional Construction 0025-3102T-5-45.2.5.2 Detailed Discussions of Bit 1 0025-3103Use it to enable/disable millimeter/inch conversion in sub scanning direction for images read in text mode.5.2.5.3 Detailed Discussions of Bit 2 0025-3104Use it to enable/disable millimeter/inch conversion in sub scanning direction for images read in text/photo mode while bit 1 is set to '1'.5.2.5.4 Detailed Discussions of Bit 3 0025-3105Use it to enable/disable transmission of bit 33 and thereafter (DIS signal).5.2.5.5 Detailed Discussions of Bit 4 0025-3106Use it to enable/disable declaration of the use of cut sheets (DIS signal).For reception of an extra-long original, select 'A4/B4 size' if division is to be by the other party.MEMO: Any of the following error code may be indicated because of an echo at time of reception##005, ##101, ##106, ##107, ##114, ##200, ##201, ##790MEMO: Any of the following error codes may be indicated at time of transmission##100, ##280, ##281, ##750, ##753, ##754, ##755, ##758, ##759, ##760, ##763 ##764, ##765, ##768, ##769,##770, ##773, ##775, ##778, ##780, ##783, ##785,##788MEMO: Any of the following error codes may be indicated at time of reception because of line condition##107, ##114, ##201Be sure to change bit 4 before changing this bit; if errors still occur, change this bit.When 'high speed' is selected, only high-speed signals (images) will be received after transmission of the CFR signal.Bit Function 1 00 not used - -1 Conversion from mm to inch (text mode) convert do not convert2 Conversion from mm to inch (text/photo mode) convert do not convert3 end DIS signal bits 33 and over prohibit do not prohibit4 Recording paper length availability declared in DIS signal A4/B4 size any size5 not used - -6 not used - -7 not used - -If 'prohibit' is selected, the Super Fine reception function or Memory Box function cannot be used for communications from non-Canon machines.MEMO:Some machines are not designed to divide extra-long originals.