Canon Super G3 Fax Board-AF1 Service Manual

Canon Super G3 Fax Board-AF1 Service Manual Manual pdf 26 page image

Chapter 22-6F-2-194) Connect the end of the PTT Cable or Telephone Cord [1] to the modularjack on the host machine, and connect the other end to the modular jackon the wall.F-2-205) Return the Left Rear Cover to its original position, and secure the ReaderCommunication Cable and the Reader Power Supply Cable in place usingthe 2 Wire Saddles.6) Affix the following Approval Label.[1] For USA[2] For other countriesF-2-217) Connect the power plug to the outlet.8) Turn ON the main power switch.2.3 Checking the Operation2.3.1 Type Settings 0024-9697Select the country/region of the FAX Board in Service Mode: FAX > TYPE> TYPEThis setting performs the parameter settings to match the communicationspecification of the country/region.1) Set the TYPE of country/region to install this machine, and then press OK.- Service Mode > FAX > TYPE > TYPE2) Turn OFF/ON the main power switch to enable this setting.2.3.2 Basic Settings 0024-7716In this section, make only minimum settings required for FAX communica-tion.1) Set the user telephone number.[Settings/Registration] > [Function Settings] > [Send] > [Fax Settings] >[Set Line] > [Line 1] > [Register User Telephone No.] > Enter FAXnumber > [OK]2) Set the type of telephone line.[Settings/Registration] > [Function Settings] > [Send] > [Fax Settings] >[Set Line] > [Line 1] > [Select Line Type] > Select the line type to connect> [OK]3) Turn OFF/ON the main power switch after setting the user telephone num-bers and the type of telephone line.2.3.3 FAX Communication Test 0024-9689Perform communication test to check if FAX function works correctly.1) Switch the control panel display to Send/Fax display.2) Send the test document from this machine to another machine that canhandle the communication test to check that this machine can send thedata correctly.3) Send the test document from the target to this machine to check if the ma-chine can receive the document properly.[1] [2] MEMO:When "System Manager Information Settings" is set, be sure to follow thedirection of user administrator in order to log in as an administrator.