10. Slide up or down the right side of the Pre-Separation Plate with the same value as procedure 8.NOTE:• Check the position scale on the right edge of the Pre-Separation Plate to adjust it.• Check that plain paper passes smoothly.L=+/-0.5mm11. Fasten the 2 screws on the right loosened at procedure 7.2x12. Enter the setting value (Adjustment of paper surface height: Deck) recorded at procedure 3 on the service mode.Service Mode > COPIER > ADJUST > FEED-ADJ > DK1-PKLV(LV1)Compartment■ Actions at Replacement“Removing the Compartment” on page 56■ Actions after Replacement1. Remove all sheets of paper from the Compartment.2. Execute the following item on the service mode.• Initialization when replacing the partsService Mode > COPIER > FUNCTION > CST > DK1-INT1(LV1)5. Adjustment93
