Paper Positioning Check /Adjustment ProcedureimageRUNNER ADVANCE8500 Series■ Adjusting the Left Edge Margin(L1)of the Image1. Print sheets of paper from the POD Deck Lite. Checkthat L1 is 2.5+/-1.5mm. Execute adjustment asfollows when it is out of standard.L1■ Adjustment Procedure(servicemode)1. Adjust the setting value on the following servicemode.Service Mode > COPIER > ADJUST > FEED-ADJ >ADJ-DK(LV1)NOTE:Setting range: -20 to 20 (0.1mm by 1 setting value)L1 is increased 0.1mm by setting value 1.+: L1 is increased (Image moves to the right).-: L1 is decreased (Image moves to the left).2. Exit service mode.3. Print sheets of paper from POD Deck Lite and thencheck that L1 is 2.5+/-1.5mm. Execute manualadjustment as follows when it is out of standard.■ Adjustment Procedure (manual)1. Press the open button of the POD Deck Lite to openthe compartment.2. Open the compartment until it stops while releasingstoppers with pressing left and right latches.6. Installation133
