NOTE:Service Mode• ON/OFF of POD Deck Lite air assist(Lv.2) COPIER > OPTION > FEED-SW > DK1-AIR• Deck Air Float Fan airflow amnt: dwstm(Lv.2) COPIER > OPTION > FEED-SW > DK1-ALVD• Deck Air Float Fan airflow amnt: upstream(Lv.2) COPIER > OPTION > FEED-SW > DK1-ALVUTo adjust the airflow amount of the Air Floatation Fan of the POD Deck Lite.When making an adjustment, be sure to adjust the setting of DK1-ALVD and DK1- ALVU at the same time.-10 to 10 [default: 0]When double-feed occursIf the value is large, uneven transfer may occur. If the value is small, double feed may occur.■ Swing OperationThis equipment combines the air blowing operation against paper with the swing operation of the shutter to improve separationof paper. The swing motor (M4) drives the shutter to move up and down.The direction of air blow against paper changes up or down repeatedly, vibrating the paper for easier separation.The swing HP sensor (SR16) detects a failure of up and down operation of the shutter and the home position of the shutter.Paper type: Different depending on the host machine.“Air Assist Control” on page 21Swing motor(M4)Swing HP sensor(SR16)ShutterCassette Heater Control (Option)To facilitate separation of paper in a high humidity environment, a cassette heater unit is available optionally. When the cassetteheater (H1) is powered, the temperature in the deck becomes suitable and thereby the humidity lowers, facilitating separation ofpaper. When the cassette heater switch mounted at the rear of this equipment is set at OFF, the cassette heater (H1) is notpowered. When the cassette heater switch is set to ON, the cassette heater is continuously powered.2. Technology22
