5. Execute the following item on the service mode.• Initialization when replacing the partsService Mode > COPIER > FUNCTION > CST > DK1-INT1(LV1)• Setting of Deck Lifter stop positionService Mode > COPIER > FUNCTION > CST > DK1-SPAD(LV1)DK1-SPAD = 1*Even DK1-SPAD is set to 1, the value is returned to 0 when the Compartment is opened.6. Check that the position between the Pre-Separation Plate and the Lifter Plate is within L=+/-0.5 mm. Adjust it on thefollowing procedure in case that it is out of standard.L7. Loosen the 4 screws on the Pre-Separation Plate.4x5. Adjustment91
