3. Loosen the 2 screws at the latch plate on the rightside of the compartment.• 2 ScrewsLoosen2x4. Move the latch plate toward front [A] or rear [B] (1scale = 1mm) and then fasten the 2 screws. Theadjusted value is used at procedure 6.• When L1 is large, move the latch plate to front [A].• When L1 is small, move the latch plate to rear [B].[A] [B]2xFasten5. Loosen the 2 screws at the latch plate on the left sideof the compartment.• 2 Screws2x Loosen6. Move the latch plate in the same scale position asprocedure 4 and then fasten the 2 screws (1 scale =1mm).2xࡿࡵ⥾Fasten7. Move the front cover fitting to the amount of the latchplate adjustment. Refer to the next item "Front CoverPositioning Adjustment" for detail.8. Close the compartment.6. Installation134
