Canon PIXMA MX870 Network Setup Manual

Also see for PIXMA MX350: Brochure User manual Manual Installation manual Install manual

Contents

Canon PIXMA MX870 Network Setup Manual Manual pdf 7 page image

AACheckThe Machine is Not Displayed (Detected)Is the machine connected to a network?To confirm the connection status, press the Setup button, then using the { } [ ] and OKbuttons, select Device settings > LAN settings > Confirm LAN settings > WLAN setting list orLAN setting list. Make sure that Connection is set to Active.•For a wireless connection, make sure that you follow Check 1, 2, 3, 4, 5 and 6 of"Connection Checklist" on page 12, then click Update (A).Check 2Check 1If the machine is not connected to a network, perform setup again by following theprocedures in "Wireless Setup" and onward or "Wired Setup" and onward in the printedmanual: Getting Started.Check 3Problems during Software InstallationIs the IP filtering feature enabled on the network device (router, access point, etc.)?Set the network device to accept the IP address of the machine.For details on how to check settings of the network device, refer to the manual supplied with thenetwork device or contact its manufacturer.•For details on how to change settings of the network device, refer to the manual supplied with thenetwork device or contact its manufacturer.•To check the IP address of the machine, press the Setup button, then using the { } [ ] andOK buttons, select Device settings > LAN settings > Confirm LAN settings > WLAN settinglist or LAN setting list, then check IP address.•For a wired connection, make sure that you follow Check 1, 2, 3, 7 and 8 of "ConnectionChecklist" on page 12, then click Update (A).WPSActionCheckCannot connect. Multiple access points are enabled. is DisplayedThe message appears when multiple access points aredetected.Check the access point settings, then configure WPSsettings again.For details on how to check the settings of the access point,refer to the manual supplied with the access point or contact itsmanufacturer.•The message appears when an error occurs.Connection failed. is DisplayedWait for a while, then configure the settings again.For the procedure to configure WPS settings of the machine,refer to "Wireless Setup Using WPS (Wi-Fi Protected Setup)" inthe printed manual: Getting Started.•When using an access point that does not support WPS, configure settings manually. For theprocedure to configure settings of the machine manually, refer to "Wireless Setup" in the printedmanual: Getting Started.•