Canon PIXMA MX870 Network Setup Manual

Also see for PIXMA MX350: Brochure User manual Manual Installation manual Install manual

Contents

Canon PIXMA MX870 Network Setup Manual Manual pdf 3 page image

AAdvanced setupSSID•An identifier to identify the specific access point.An access point's periodic transmission of a signal revealing its SSID.Stealth mode•A function to prevent the SSID of the access point from appearing on other wireless devices.SSID broadcast•GlossaryA function to block access from unauthorized wireless devices by saving the MAC addresses of specificwireless devices (computers, printers, etc.) to the access point beforehand.MAC address filtering•A unique number assigned to each network device.MAC address•Problems during Network SetupEasy setupCheckThe Target Access Point is Not Displayed (Detected)Make sure that you follow Check 1, 2, 5 and 6 of"Connection Checklist" on page 12, then press the leftFUNCTION button (A) on the machine to search for theaccess point again.Turn off the access point, then turn it backon, then press the left FUNCTION button(A) on the machine to search for theaccess point again.Is SSID broadcast (connection via "ANY"SSID, etc.) disabled or is the stealth modeenabled on the access point?For details on how to check the settings of theaccess point, refer to the manual supplied withthe access point or contact its manufacturer.•Enable SSID broadcast (connection via"ANY" SSID, etc.) or disable the stealthmode, then press the left FUNCTIONbutton (A) on the machine to search for theaccess point again.For details on how to change the settings of the access point, refer to the manual supplied with theaccess point or contact its manufacturer.•To establish a connection without changing the access point settings, refer to "Enteringthe Access Point's Wireless LAN Settings Directly on the Machine" on page 9.Check 3Check 2Check 1Is the MAC address filtering enabled on the access point?Set the access point to accept the MAC address of themachine.Check 4For details on how to change the settings of the access point,refer to the manual supplied with the access point or contact itsmanufacturer.•To check the MAC address of the machine, press the Setupbutton, then using the { } [ ] and OK buttons, selectDevice settings > LAN settings > Confirm LAN settings >WLAN setting list, then check MAC address.•For details on how to check the settings of the access point, refer to the manual supplied with theaccess point or contact its manufacturer.•Is "WPA/WPA2 Enterprise" set as a security protocol (encryption standard) on theaccess point?Check 5"WPA/WPA2 Enterprise" is not supported on the machine.Change the security protocol (encryption standard) for the access point, then configuresettings again.For details on how to change the security protocol (encryption standard) for the access point, referto the manual supplied with the access point or contact its manufacturer.•For the procedure to configure settings of the machine, refer to "Wireless Setup Using EasySetup" in the printed manual: Getting Started.•