Canon PIXMA MX870 Network Setup Manual

Also see for PIXMA MX350: Brochure User manual Manual Installation manual Install manual

Contents

Canon PIXMA MX870 Network Setup Manual Manual pdf 5 page image

CheckThe message appears when no access point is found bythe entered access point name/network name (SSID).Press the OK button to make sure that the entered accesspoint name/network name (SSID) is correct, then press theOK button again.Check 1Is the entered access point name/network name (SSID)correct?Is the MAC address filtering enabled on the access point?Set the access point to accept the MAC address of themachine.Check 4For details on how to change the settings of the access point,refer to the manual supplied with the access point or contact itsmanufacturer.•To check the MAC address of the machine, press the Setupbutton, then using the { } [ ] and OK buttons, selectDevice settings > LAN settings > Confirm LAN settings >WLAN setting list, then check MAC address.•For details on how to check the settings of the access point, refer to the manual supplied with theaccess point or contact its manufacturer.•Make sure that you follow Check 1, 2, 5 and 6 of "Connection Checklist" on page 12.Turn off the access point, then turn it back on.Check 3Check 2After that, press the OK button, then proceed with the setup from in "Entering the AccessPoint's Wireless LAN Settings Directly on the Machine" on page 9.•After that, press the OK button, then proceed with the setup from in "Entering the AccessPoint's Wireless LAN Settings Directly on the Machine" on page 9.•The directly entered access point was not detected. is DisplayedAfter that, press the OK button, then proceed with the setup fromin "Entering the Access Point's Wireless LAN Settings Directlyon the Machine" on page 9.•CheckMultiple access points with the same name exist. is DisplayedSelect Use multiple AccessPoints.For details on how to check the MAC address of the accesspoint, refer to the manual supplied with the access point orcontact its manufacturer.•Select Use one AccessPoint only, then select the MACaddress of the target access point.When using multiple access pointsGlossaryA unique number assigned to each network device.MAC address•For subsequent operations, go to or / / in "Entering the Access Point'sWireless LAN Settings Directly on the Machine" on page 9.•For subsequent operations, go to or / /in "Entering the Access Point's Wireless LAN Settings Directlyon the Machine" on page 9.•When you have only one access pointThe message appears when multiple access points with thesame name are found.