Canon PIXMA MX870 Network Setup Manual

Also see for PIXMA MX350: Brochure User manual Manual Installation manual Install manual

Contents

Canon PIXMA MX870 Network Setup Manual Manual pdf 11 page image

123467598ActionUse the { or } button to select Other setup, thenpress the OK button.Select Yes, then press the OK button.Use the [ or ] button to select Wireless LAN Setup,then press the OK button.Press the Setup button.Enter the access point name/network name (SSID) and security setting (WEP, WPA,etc.) on the machine directly.Follow the procedure below.When wireless connection is enabled, the Wi-Fi lamp lightsblue.•Select Directly enter the access point name, thenpress the OK button.If you are living in an apartment, nearby access points in usemay be detected.•Enter the access point name/network name (SSID)using the Numeric buttons, then press the OK button.For details on how to check the access point name/networkname (SSID), refer to the manual supplied with the accesspoint or contact its manufacturer.•Enter the same access point name/network name (SSID) asthat of the access point on the machine.•Enter upper and lower case letters of the alphabet correctly. Letters are case sensitive.•Entering the Access Point's Wireless LAN Settings Directly on theMachineFor details on how to enter characters, refer to "CharacterEntry" on page 8.Select Advanced setup, then press the OK button.Go to either of the following steps according to the selectedsecurity protocol.•DisableWEPWPA/WPA2Go to on page 10.Go to on page 10.Go to on page 10.Select a security protocol for the access point, thenpress the OK button.When WEP 40 bit or WEP 128 bit is selected in AirPort Utility (AirPort Admin Utility), selectWEP.•When WEP (Transitional Security Network) is selected in AirPort Utility, select WPA2-PSK(AES).•Make sure that the access point name/network name(SSID) is correct, then press the OK button.