Canon PIXMA MP130 Easy Setup Instructions

Also see for PIXMA MP130: Supplementary guide Quick start guide Service manual Quick start guide

Contents

Canon PIXMA MP130 Easy Setup Instructions Manual pdf 1 page image

1 Unpack and setup the machine.1 Carefully remove all items from the box.2 Remove the protective material.3 Place the machine on a flat surface.4 Remove all shipping tape and the protective sheet.5 Lift the Scan Unit (1) until it locks into place, and remove the packing material(2) from the Print Head Holder.• Be sure to hold the machine by the side. Do not lift the machine by grasping the Paper Support Extensionor the Operation Panel.X Check the contents.• A printer cable is not included. You must purchase a USB cable (less than 10 ft./3 m) to connect yourmachine to a computer.• Please note that the items included with your machine may vary depending on the country of purchase.2 Connect the power cord.2 If the message appears, go to Step 3, “Install the printhead.”3 Install the print head.1 Lift the Scan Unit until it locks into place.2 Open the Paper Output Tray (1).4 Install the ink tanks.1 Remove the orange protectivecap.2 Insert the ink tanks.• Insert the black ink tank into the right slot, and the color ink tank into the left slot.IMPORTANT• For correct printer operation, make sure ink tanks are secure in slots.3 Close the Inner Cover (1) and the ScanUnit (2).4 If the LCD displays messages asking ifyou replaced the ink tanks, press [ ]repeatedly to complete the installation.5 Load the paper.1 Open the Paper Support (1) and pull up the Paper Support Extension (2) untilit stops.• If you are loading the legal-size paper, set the Attachment (3) to the Paper Support.2 Load the paper with the print side face up.• Ensure the paper stack does not exceed Paper Limit Mark.3 Pinch and adjust the Paper Guide to the width of the stack.Setup is complete.If you are connecting the machine to a computer for use, see the reverse side for instructions oninstalling the software.• Machine • Power cord• Print head • Ink tanksBCI-24 BlackBCI-24 Color• Paper Support Attachment• Safety Instructions • Easy Setup Instructions• Quick Start Guide • Setup CD-ROMThe Setup CD-ROM contains the MP Drivers, as well as the electronic manuals User’s Guide, SoftwareGuide and Photo Application Guide. Please read these guides.1 Connect the power cord.(1)(2)(1)(2) PLEASE WAIT3 Open the Inner Cover (2).• The Print Head Holder moves to the center.Install the print head here (3).4 Raise the Lock Lever.5 Remove the protective cap. 6 Insert the print head.• Do not press it down.7 Lower the Lock Lever until it locksinto place.(3)(1)(2)Do not touch!Do not touch!(2)(1)(2)(1)(3)Start HereEasy Setup InstructionsCanon and BCI are registered trademarks and PIXMA is a trademark of Canon Inc.All other products and brand names are registered trademarks or trademarks of their respective owners.Specifications subject to change without notice.HT7-0095-000-V.1.0 xx2004A © CANON INC. 2004 PRINTED IN CHINA

/ 2

Related manuals for Canon PIXMA MP130