[Default Policy]Select the precondition to allow or reject the communication of other devices with the machine.[Reject]Select to pass communication packets only when they are sent to or received fromdevices whose IP addresses are entered in [Exception Addresses]. Communicationswith other devices are prohibited.[Allow]Select to block communication packets when they are sent to or received fromdevices whose IP addresses are entered in [Exception Addresses]. Communicationswith other devices are permitted.2 Specify address exceptions.● Enter the IP address (or the range of IP addresses) in the [Address to Register] text box and click[Add].Check for entry errors● If IP addresses are incorrectly entered, you may be unable to access the machine from the Remote UI,in which case you need to set or to . IPv4 AddressFilter(P. 365) IPv6 Address Filter(P. 366)Entry form for IP addressesDescription ExampleEntering a single addressIPv4:Delimit numbers with periods. 192.168.0.10IPv6:Delimit alphanumeric characters withcolons.fe80::10Specifying a range of addresses Insert a hyphen between the addresses. 192.168.0.10-192.168.0.20Specifying a range of addresses with a prefix Enter the address, followed by a slash anda number indicating the prefix length.192.168.0.32/27fe80::1234/64When [Reject] is selected for an outbound filter● Outgoing multicast and broadcast packets cannot be filtered.Deleting an IP address from exceptions● Select an IP address and click [Delete].3 Click [OK].6 Restart the machine.● Turn OFF the machine, wait for at least 10 seconds, and turn it back ON.Security240
