Canon LASERBASE MF3110 User Manual

Also see for LASERBASE MF3110: Service manual Service manual

Contents

Canon LASERBASE MF3110 User Manual Manual pdf 61 page image

9-13Troubleshooting9Q Is the exposure adjusted correctly?A Adjust the exposure correctly using [Exposure]. (See "Adjusting the Exposure (Density)," on p. 5-3.)Copies are dirty.Q Is the platen glass or the platen glass cover clean?A Clean the platen glass or the platen glass cover. (See "Cleaning the Scanning Area," on p. 8-1.)Q Is the cartridge free of damage?A If there is a scratch on the cartridge, replace with a new one. (See "Replacing the Cartridge," on p.8-5.)Q Is the machine adjusted to room temperature? If not, condensation might build up inside themachine.A Allow at least 2 hours for the machine to adjust to room temperature before attempting to use it.Q Is the machine installed in a stable location?A Install the machine in a proper location. (See Chapter 1, "Safety Instructions," in the QuickReference Guide.)Copies are too dark or too light.Q Is the exposure adjusted correctly?A Adjust the exposure correctly using [Exposure]. (See "Adjusting the Exposure (Density)," on p. 5-3.)Q Is the machine in the toner saver mode?A Set to in of the Menu. (See <2. TONERSAVER MODE> of "Menu Descriptions," on p. 10-2.)The printouts are partly missing or shaded when you make copies on heavy paper.Q Is the paper type set correctly?A Select or in in of theMenu. (See "Specifying the Paper Type," on p. 2-9.)