Chapter 44-22F-4-334.3.1.6 Height 0003-18491) With the machine closed, check to see if the heightadjusting rolls [1] found at the left rear and front arein contact with the reading glass [2].F-4-34Memo:To facilitate the work, try executing the following toturn on the scanning lamp using the host machine'sservice mode: COPIER>FUNCTION>MISC-R>SCANLAMP.If the height adjusting rolls [1] at the left front andrear are not in contact with the reading glass [2],turnthe fixing screw [3] found at the top of the left hinge.F-4-354.3.1.7 Right Angle 0003-2252The following steps adjust the relationship betweenthe machine's original feed direction and the hostmachine's scanner system:1) Place the Test Chart in the machine, and make acopy.2) Check the right angle of the image in relation to theleading edge of the output (i.e., angle A).F-4-363) Loosen the 2 knurled screws found at the front ofthe right hinge unit.4) Bend over the edge of the rubber cover [2] found at[1][2][3][4][1][2][3][A]
