|
Chapter 33-18F-3-1042) Set the test chart on the original pickup tray, and execute a 100% magni-fication copy.3) Lay the test chart on top of the image outputted in step 2) to confirm theimage is within the following standard value.ABGo to step 4, when the image is not within the standard value.F-3-1054) Press "2" and "8" at the same time then "User mode key" on the controlpanel to move to the service mode.5) Select: COPIER>ADJUST>ADJ-XY>ADY-Y-DF and change the settingto adjust.If enlarging the setting, A margin will be larger and B margin will besmaller.[1 measure: 0.1mm]6) Print a test chart and verify if image is within the standard value.b. Adjusting the Position of the Side Guide Plate on the ADF PickupTray1) Open the feeder cover ant detach the inside cover.2) Detach the cover [2].- 3 screws [1]F-3-1063) Loosen the screw [1] and remove the screw [2] from the positioning holeside, and then tighten it temporarily with the adjusting long hole [3].In case of A > 1mm : Move the volume unit to the front sideIn case of B > 1mm : Move the volume unit to the rear sideF-3-1074) Move the original width volume unit [4] to the front or rear side to adjust.5) Tighten the screw [1] loosened before and the screw fixed with the adjust-ing long hole [3].6) Attach the cover after adjusting.7) Print a test chart and verify if the image is within the standard values.3.5.3 Pressurization Solenoid3.5.3.1 Before Removing the Pressurization Solenoid 0017-65391) Remove the front cover. (page 3-1)Reference[Removing the Front Cov-er]3.5.3.2 Removing the Pressurization Solenoid 0017-65411) Remove the Pressurization solenoid [3].- 2 screws [1]- 1 spring [2]F-3-1083.5.4 ADF Driver PCB3.5.4.1 Before Removing the ADF Drover PCB 0017-65421) Removing the rear cover. (page 3-2)Reference[Removing the Rear Cov-er]3.5.4.2 Removing the ADF Driver PCB 0017-65431) Remove the harness guide [3].- 3 screws [1]- 7 connectors [2]Right angle10mm 10mm10mm 10mmFeeddirectionPaper used in step 2)ATest ChartFeeddirectionPaper used in step 2)BTest Chart[1][2][1] [2] [3][4][2][3][1]
|
