Chapter 33-6Moreover, be sure that the separation front guide [7] is mounted so that thewider side of the sheet [8] is toward the pickup roller side.3.4.3 Separation Plate/Separation Pad3.4.3.1 Before Removing the Separation Plate/SeparationPad 0017-64191) Remove the inside cover. (page 3-2)Reference[Removing the InsideCover]2) Remove the pickup roller unit. (page 3-5)Reference[Before Removingthe Pickup Roller Unit]3.4.3.2 Removing the Separation Plate/Separation Pad 0017-64251) Remove the separation plate [2] and the separation pad [3].- 2 screws [1]F-3-303.4.3.3 Adjusting the Separation Pressure 0017-6428MEMO:Make the following adjustments if such feeding faults as multiple feedingoccur.T-3-11) Turn over the pressure adjusting roll [1] (found fitted to the spring), andfit it in place (turn it over from side A to side B).F-3-31When fitting the spring in place, be sure it is oriented correctly, i.e., thespring [1] with a bend being upstream in relation to feed direction.F-3-323.4.4 No.1 Registration Roller Roll3.4.4.1 Before Removing the No. 1 Registration RollerRoll 0017-64321) Remove the front cover. (page 3-1)Reference[Removing the Front Cov-er]2) Remove the feeder cover. (page 3-2)Reference[Removing the FeederCover]3.4.4.2 Removing the No. 1 Registration Roller Roll 0017-64361) Remove the cover [2].- 4 screws [1]F-3-332) Remove the support plate; then, detach the No. 1 registration roller roll[2].- 1 screw [1]F-3-34Pressure adjustingrollSeparation pressureSide A lowSide B high[2][3][1][1][1][1][2][2][1]
