Chapter 33-8Cover]3.4.6.2 Removing the No. 2 Registration Roller Roll 0017-64911) Remove the cover [2].- 4 screws [1]F-3-422) Remove the support plate; then, detach the No. 2 registration upper rollerroll [2].- 1 screw [1]F-3-433.4.7 No.2 Registration Roller3.4.7.1 Before Removing the No. 2 Registration Roller 0017-64951) Remove the front cover. (page 3-1)Reference[Removing the Front Cov-er]2) Remove the rear cover. (page 3-2)Reference[Removing the Rear Cover]3) Remove the cooling fan. (page 3-17)Reference[Removing the CoolingFan]3.4.7.2 Removing the No. 2 Registration Roller 0017-65051) Loosen the 2 screws [1], and move down the feed motor [2]; then, tightenthe 2 screws you have loosened [1].F-3-44When mounting it, be sure to loosen the screws [1] and move the feed motor[2] back into its initial position.2) Remove the feed motor unit [3].- 4 screws [1]- 1 connector [2]F-3-45When mounting it, be sure that the timing belt [1] is properly attached to thepulley [2].F-3-463) Detach the No.2 registration roller [4].- 3 E-rings [1]- 3 gears [2]- 2 bushings [3]F-3-47[1][2][2][1][1][1][2][1][1] [2][3][1][2][4][1] [1][2][3][1][2][3]
