OverviewAdjustment After Replacing the PartsIn case of removing the parts as shown below, adjust the following item.Parts to replace Adjustment item ReferenceMotor/Other roller Adjusting the Magnification “Adjusting the Magnification” on page 103AdjustmentIn case of removing this equipment and then re-installed, adjust it in order as shown below.No. Adjustment item Reference1 Adjusting the Height “Adjusting the Height” on page 702 Adjusting the Perpendicularity “Adjusting the Perpendicularity” on page743 Adjusting the Reading Position “Adjusting the Reading Position” on page784 Adjusting the Magnification “Adjusting the Magnification” on page 795 Adjusting the Image Position (Horizontal Scanning Direction) “Adjusting the Image Position (Main Scan-ning Direction)” on page 806 Adjusting the Image Position (Leading Edge) “Adjusting the Image Position (Sub ScanningDirection)” on page 817 Adjusting the White Level “Adjusting the White Level” on page 82Preparation or Creation of Test ChartPrepare a test chart. If there is no test chart, create a test chart.Create a test chart that has a 10 mm smaller rectangle from the edge of A4 or LTR paper.NOTE:Be sure to write a character or mark to identify the printed image direction.10 mm10 mm10 mm10 mm5. Adjustment69
