Adjusting the Image Position(Main Scanning Direction)1. Copy the test chart with the DADF.2. Compare the horizontal registration between thecopy and the test chart. As necessary, make thefollowing adjustment.■ Adjustment Procedure1. Select the following item in the service mode.COPIER > ADJUST > ADJ-XY > ADJ-Y-DF2. Change the value as gap A in the figure.• If the image is displaced to the rear: Increase thevalue. (The image shifts to the front.)• If the image is displaced to the front: Decrease thevalue. (The image shifts to the rear.)Setting Value; 1=0.1mmFeed directionARear side ofprinted imageRear side oftest chart image< If the image is displaced toward rear >Feed directionARear side oftest chart imageRear side ofprinted image< If the image is displaced toward front >3. When the setting value was changed in step 2, writedown the new numerical value in the service label.NOTE:The service label affixed to the back of Reader FrontCover.6. Installation104
