Adjusting the Image Position(Sub Scanning Direction)1. Copy the test chart with the DADF.2. Compare the leading edge registration between thecopy and the test chart. As necessary, make thefollowing adjustment.■ Adjustment Procedure1. Select the following item in the service mode.FEEDER > ADJUST > DOCST2. Change the value as gap A in the figure.• If the image is displaced to the trailing edge:Increase the value. (The image shifts to the leadingedge.)• If the image is displaced to the leading edge:Decrease the value. (The image shifts to the trailingedge.)Setting Value; 1=0.1mmFeed directionALeading edge oftest chart imageLeading edge ofprinted image< If the image is displaced toward trailing edge >Feed directionALeading edge ofprinted imageLeading edge oftest chart image< If the image is displaced toward leading edge >3. When the setting value was changed in step 2, writedown the new numerical value in the service label.NOTE:The service label affixed to the back of Reader FrontCover.6. Installation105
