Canon C9075 PRO Operating Manual

Contents

Canon C9075 PRO Operating Manual Manual pdf 197 page image

List of Error Messages 2-1092TroubleshootingList of Error MessagesThis section explains the various messages that appear on the touch panel display, along with possible causes and remedies.For explanations of messages that are not listed here, see e-Manual >Scan and Send, Using the Machine to Send/Receive a Faxand Network.Self-Diagnostic DisplayIf the machine displays a self-diagnostic error message, follow the instructions on the touch panel display.Self-diagnostic error messages appear on the touch panel display at the following times:When scanning or printing cannot be performed because of an operational error.When you need to make a decision or take some action during scanning, copying, or printing.When you need to make a decision or take some action while browsing the network.The following is a list of self-diagnostic error messages, along with their possible causes and remedies.Load paper.Cause 1 The machine has run out of paper. No more prints can be made.Remedy Load paper. (See “Paper Drawers,” on p. 1-2.)Cause 2 The paper drawer is not correctly inserted.Remedy Insert the paper drawer as far as it will go. (See “Paper Drawers,” on p. 1-2.)Load LTR size paper.Cause The optimum paper size selected by the Automatic Paper Selection mode is not available in the machine.Remedy 1 Load the indicated paper size into the machine. If you press (Start) while this message is displayed, prints are made with thecurrently selected paper size.Remedy 2 If the message continues to be displayed even if the indicated paper size is loaded, set Paper Drawer Auto Selection On/Off inFunction Settings (from the Settings/Registration screen) for that paper drawer to ‘On’. (See e-Manual > Settings/Registration)Return page 1 to the top, and then press the [Start] key.Cause Scanning was stopped due to a problem with the feeder.Remedy Arrange the originals in page order with the first page on top. Place the originals back into the feeder’s original supply tray, andpress (Start).Return page 1 to the top, and then press the [Start] key. (Data for the scanned original has exceeded limits on the size that can be handled bythis machine. Automatically adjust settings and try again.)Cause Scanning has stopped because the data size of the scanned original exceeds the maximum data size that the machine can handle.Remedy Try scanning the original again from the first page. If scanning is still not possible, reduce the Sharpness mode setting, and select[Text] for the original type.Scanning has stopped because the size of the data for the scanned original exceeds the limit. Scanning may be possible if [Sharpness] isreduced and the type of original is set to [Text].Cause Scanning has stopped because the data size of the scanned original exceeds the maximum data size that the machine can handle.Remedy Reduce the Sharpness mode setting, and select [Text] for the original type.•••