Service Call Message 2-1212TroubleshootingSetting the Limited Functions Mode from the Service Call Message ScreenIf the Service Call Message screen appears indicating a malfunction of a Finisher mode, you can clear it by turning the LimitedFunctions Mode ‘On’ to temporarily limit the use of the finishing modes. However, after the Limited Functions Mode is deactivated,the Service Call Message screen may appear again, unless the cause of the malfunction is removed.If you shutdown the machine when there is a job waiting to print, that job is erased.If you set Limited Functions Mode to ‘On’ from the Service Call Message screen, Limited Functions Mode in Management Settings (from theSettings/Registration screen) is also set to ‘On’. (See e-Manual > Security.)1 Press [Limited Functions Mode]2 Press [Yes]A message prompting you press [Shutdown] and to turn the main power switch back ON appears.3 Press the main power switch to the “ ” sideWhen operating the main power switch, open the main power switch cover.( side)4 Wait at least 10 seconds after the Main Power Indicator is turned off, and then turn the main powerswitch back to “I“ sideWhen operating the main power switch, open the main power switch cover.( I side)The machine starts up in the Limited Functions mode.
