Routine Cleaning1-721Routine MaintenanceAutomatic Feeder CleaningIf your originals have black streaks or appear dirty after scanning them through the feeder, clean the rollers of the feeder.It takes approximately 20 seconds to clean the feeder.Feeder Cleaning cannot be performed during printing.1 Press (Settings/Registration) → [Adjustment/Maintenance] → [Maintenance] → [Clean Feeder]2 Place 10 sheets of blank paper into the feeder → press [Start]Make sure that you fan the sheets of paper well.Use normal LTR paper.When cleaning is complete, try scanning again.To cancel feeder cleaning while it is in progress, press [Cancel].Wire CleaningIf streaks appear on printed output or random parts of the printed image are missing, clean the corona assembly wires inside themain unit.It takes approximately 35 seconds to clean the wire.Wire cleaning cannot be performed during printing.1 Press (Settings/Registration) → [Adjustment/Maintenance] → [Maintenance] → [Clean Wire]2 Press [Start]When cleaning is complete, try printing again.Roller CleaningIf dirt or streaks appear on printed output, clean the roller inside of the main unit.It takes approximately 20 seconds to clean the roller.Roller cleaning cannot be performed during printing.1 Press (Settings/Registration) → [Adjustment/Maintenance] → [Maintenance] → [Clean Roller]2 Press [Start]When cleaning is complete, try printing again.••••••
