MAINTENANCE PROCEDURESwith the Vehicle Identification Number(V.I.N.) (p. 152) and its current ownerinformation.If you replace any tire on your vehi-cle, a "Tire Registration Form" must becompleted and sent to the tire manu-facturer consumer service group. The“Tire Registration Form” is available atan authorized Can-Am roadster dealer.Drive BeltVisually inspect belt alignment andcondition before each ride. Refer toMAINTENANCE SCHEDULE (p. 110)for scheduled maintenance intervals.Belt alignment and deflection adjust-ment should always be performed byan authorized Can-Am roadster dealer.Drive Belt AlignmentThe gap between the belt (2) and thesprocket internal flange (3) shouldbe a minimum of 1 mm (1/32 in). Ifbelt goes beyond the outside edge ofsprocket (5), have the belt properlyaligned by an authorized Can-Am road-ster dealer as soon as possible.rmo2008-001-027_aBELT ALIGNMENT1. Rear sprocket teeth2. Belt3. Sprocket internal flange4. Proper belt alignment5. Belt exceeding external edge – have alignedA. MIN. 1 mm (1/32 in)Drive Belt WearInspect the drive belt with the vehiclein neutral, engine off, on a level surfacewith plenty of room — you will have toroll the vehicle forward or backward tosee the full length of the belt.rmo2008-001-109_aDRIVE BELT SURFACES1. Outer surface2. Teeth side surface3. ToothInspect for the following conditions:______________ 121
