Black plate (27,1)Cadillac Escalade/Escalade ESV Owner Manual - 2013 - CRC 2nd Edition - 10/9/12Driving and Operating 9-27If you have to leave the vehicle withthe engine running, be sure thevehicle is in P (Park) and theparking brake is firmly set. After theshift lever is moved into P (Park),hold the regular brake pedal down.Then, see if you can move the shiftlever away from P (Park) withoutfirst pulling it toward you. If you can,it means that the shift lever was notfully locked into P (Park).Torque LockIf you are parking on a hill and youdo not shift the transmission intoP (Park) properly, the weight of thevehicle can put too much force onthe parking pawl in thetransmission. It might be difficult topull the shift lever out of P (Park).This is called torque lock. Toprevent torque lock, set the parkingbrake and then shift into P (Park)properly before you leave the driverseat. To find out how, see ShiftingInto Park on page 9‑26.When you are ready to drive, movethe shift lever out of P (Park) beforereleasing the parking brake.If torque lock does occur, you mightneed to have another vehicle pushyours a little uphill to take some ofthe pressure from the parking pawlin the transmission. Then youshould be able to pull the shift leverout of P (Park).Shifting out of ParkThis vehicle is equipped with anelectronic shift lock release system.The shift lock release isdesigned to:. Prevent ignition key removalunless the shift lever is inP (Park) with the shift leverbutton fully released.. Prevent movement of the shiftlever out of P (Park), unless theignition is in ON/RUN or ACC/ACCESSORY and the regularbrake pedal is applied.The shift lock release is alwaysfunctional except in the case of anuncharged or low voltage (less than9 volt) battery.If the vehicle has an unchargedbattery or a battery with low voltage,try charging or jump starting thebattery. See Jump Starting onpage 10‑83 for more information.To shift out of P (Park) use thefollowing:1. Apply the brake pedal.2. Move the shift lever to thedesired position.If you still are unable to shift out ofP (Park):1. Ease the pressure on the shiftlever.2. While holding down the brakepedal, press the shift lever allthe way into P (Park).3. Move the shift lever to thedesired position.