Black plate (33,1)Cadillac Escalade/Escalade ESV Owner Manual - 2013 - CRC 2nd Edition - 10/9/12Instruments and Controls 5-33PARKING ASSIST OFFAfter the vehicle has been started,this message displays to remind thedriver that the Ultrasonic RearParking Assist (URPA) system hasbeen turned off. Press the set/resetbutton to acknowledge this messageand clear it from the DIC display. Toturn the URPA system back on, seeUltrasonic Parking Assist onpage 9‑44.SERVICE PARKING ASSISTThis message displays if there is aproblem with the Ultrasonic RearParking Assist (URPA) system. Donot use this system to help youpark. See Ultrasonic Parking Assiston page 9‑44 for more information.See your dealer for service.SERVICE SIDE BLIND ZONEALERT SYSTEMIf your vehicle has the Side BlindZone Alert (SBZA) system and thismessage displays, both SBZAdisplays will remain on indicatingthere is a problem with the SBZAsystem. If these displays remain onafter continued driving, the systemneeds service. See your dealer. SeeSide Blind Zone Alert (SBZA) onpage 9‑45 for more information.SIDE BLIND ZONE ALERTSYSTEM OFFIf your vehicle has the Side BlindZone Alert (SBZA) system, thismessage displays when the SBZAsystem has been turned off. SeeSide Blind Zone Alert (SBZA) onpage 9‑45 and Driver InformationCenter (DIC) on page 5‑23 for moreinformation.SIDE BLIND ZONE SYSTEMUNAVAILABLEIf your vehicle has the Side BlindZone Alert (SBZA) system, thismessage displays when the SBZAsystem is disabled because thesensor is blocked and cannot detectvehicles in your blind zone. Thesensor may be blocked by mud, dirt,snow, ice, or slush. This messagemay also display during heavy rainor due to road spray. It may alsocome on when driving in isolatedareas with no guardrails, trees,or road signs and light traffic. Yourvehicle does not need service. Forcleaning instructions, see “WashingYour Vehicle” in Exterior Care onpage 10‑90. See Side Blind ZoneAlert (SBZA) on page 9‑45 for moreinformation.Ride Control SystemMessagesSERVICE STABILITRAKIf your vehicle has StabiliTrak andthis message displays, it meansthere may be a problem with theStabiliTrak system. If you see thismessage, try to reset the system.Stop; turn off the engine for at least15 seconds; then start the engineagain. If this message still comeson, it means there is a problem. Youshould see your dealer for service.The vehicle is safe to drive,