6 Configuration HandscannerBCS 3600 ex series52 / 106 Subject to technical modificationsRevision A / 04/2019- Cradle Contact Batch ModeThe digital scanner starts saving barcode data when batch mode is activated. Data transferis initiated by inserting the digital scanner into the holder.- Batch Mode OnlyThe scanner radio is turned off and the scanner stores all barcode data. The data transfer istriggered by inserting the scanner into the holder.- Batch Mode ParametersWhen parameter batch mode is enabled and there is no connection to the base station, thescanner starts saving parameter barcode data intended for the base station. The transfer ofthe parameter barcode is triggered by inserting the scanner into the base station. The BatchMode parameter is exited at the end of the transfer. Alternatively, the dosing of parameterbarcodes can be aborted by scanning the output parameter batch mode before inserting thescanner into the holder.The parameter batch mode can be used when the station and/or scanner is configured withthe radio turned off or connected to a non-battery charger.Prefix and SuffixDetailed information and programmable codes for "Prefix" and "Suffix" can be found in the ZebraProduct Reference Manual "Chapter 5 - User Settings & Other Options --- User Settings ---Prefix/Suffix Values".Another way to set up prefix and suffix is to use the Zebra 123 Scan Utility.Data chainStart Data length Prefix Scanned data Suffix EndPrefix: Add a character or string before the scanned data.Suffix: Adds a character or string after the scanned data.Adding an Enter keyTo add an Enter key (carriage return/line feed) after the scanned data, scan the following barcode.To program other prefixes and/or suffixes, refer to the Zebra Product Reference Guide.Adding an Enter field (Carriage Return/LineFeed)Table 46 Barcode for adding an Enter field
