9-26enclosure Commandsenclosure show fanTo display the status of a specific fan on a specific SAF-TEenclosure management device, use the enclosure show fancommand. You can also use this command to display the status ofall fans on the enclosure management device or devices.Syntaxenclosure show fan [{enclosure}] [{fan}]Parameters{enclosure}Specifies the ID associated with the enclosure managementdevice for which you want to display fan status information.For this version, the controller supports a maximum of eightenclosure management devices on each bus.If you do not specify a unit number, the command displaysthe fan status for all enclosure management devicesconnected to the controller.{fan}Specifies the unit number associated with the fan whosestatus you want to display. This integer can range from 0 to 15inclusive.If you do not specify a unit number, the command displaysthe status for all fans on the enclosure management device ordevices.ExamplesThe following example displays the status of all fans on enclosuremanagement devices 0 and 1:AAC0>enclosure show fanExecuting: enclosure show fanEnclosure Fan Status--------- --- -------------0 0 OK1 0 NOT INSTALLED
