9-15enclosure Commandsenclosure set fanTo set the speed of a specific fan on a specific SAF-TE enclosuremanagement device, use the enclosure set fan command.Syntaxenclosure set fan [/off{=boolean}] {enclosure}{fan} [{speed}]Parameters{enclosure}Specifies the ID associated with the enclosure managementdevice on which you want to set the speed of a specific fan.For this version, the controller supports a maximum of eightenclosure management devices on each bus.{fan}Specifies the unit number associated with the fan whosespeed you want to set. The unit number for the fan rangesfrom 0 to 15 inclusive.{speed}Specifies the speed at which you want to set this fan. Table 9-3lists the fan speed values you can specify.Table 9-3 Fan Speed ValuesThe fan speed defaults to full speed.Value Meaning0 Turns off the fan1 Runs the fan at 1/4 the full speed.2 Runs the fan at 1/2 the full speed.3 Runs the fan at 3/4 the full speed.4 Runs the fan at full speed.
