9-14enclosure Commandsenclosure set doorTo lock or unlock a specific door on a specific SAF-TE enclosuremanagement device, use the enclosure set door command.Syntaxenclosure set door [/lock{=boolean}] {enclosure}{door}Parameters{enclosure}Specifies the ID associated with the enclosure managementdevice on which you want to lock the door. For this version,the controller supports a maximum of eight enclosuremanagement devices on each bus.{door}Specifies the unit number of the door for which you want toset the lock. This number can range from 0 to 15 inclusive.Switches/lock{=boolean}Specifies whether to lock the door associated with thespecified unit number. If you set this switch to TRUE, thecommand locks the door associated with the specified unitnumber. If you set this switch to FALSE, the commandunlocks the door associated with the specified unit number.This switch defaults to FALSE.ExamplesThe following example locks the door associated with unit 1 onenclosure management device 0:AAC0>enclosure set door /lock=TRUE 0 1Executing: enclosure set door /lock=TRUE 0 1Related Commandsenclosure commands: enclosure list (page 9-6)
