Configuration Guide Branch Settings18718.6 Branch SettingsFlowchart: Configuring the LAN-to-LAN SettingsAuthorisation method of the localLAN: CLID, PAP or CHAP?Authorisation method of the remoteLAN: CLID, PAP or CHAP?LANNET Configuration:LANProtocolTelephone number localIP address localNetwork mask localUser name localCLIDPassword localTelephone number remoteIP address remoteNetwork mask remoteCLIDUser name remotePassword remoteDirection of connectionMaximum connectiontime per monthMaximum idle timeAdd internal telephonenumber to the incoming calldistribution scheme.FinishedNoYesNoNoSelect between PPP and HDLC transparent.Enter the internal telephone number.Enter the local IP address.Enter the local network mask.Specify the user name with which theremote LAN can access a destination.Specify the password with which theremote LAN can access a destination.Specify the telephone number of the remote LAN access.Specify the IP address of the remote LAN.Specify the network mask of the remote LAN.Specify the user name with whichthe remote LAN can be accessed.Specify the password with whichthe remote LAN can be accessed.Select the direction of the connection.Specify the maximum number of minutes per monththe connection to the remote LAN can be set up for.Set the maximum idle time after which aconnection to the remote LAN is cleared down.Have you made the networksettings for the OpenCom?Configure the LAN-LANconnection.“NET Configuration: Branch”Configure the network-settings for the OpenCom.YesYes
