Voice over IP (VoIP) Media Gateway (MGW)11810.2.1 MG+ETH1-1Field of ApplicationThe MG+ETH1-1 interface card provides 16 Media Gateway channels for VoIP.The MG+ETH1-1 interface card can be installed in any of the OpenCom 510’s slots(1 to 12, see also the chapter Slots starting on page 27). Up to four MG+ETH1-1interface cards can be operated.Technical Data■ OpenCom 510 can be connected to the LAN via the ethernet port (10/100 Mbit/s).■ The interface card supports: all codecs used by VoIP telephones, silencedetection, echo suppression and DTMF tone detection.■ The interface card can not be used in a slave system.■ The interface card acquires its software from the system. After the card hasbeen installed it will automatically load the required software.■ No settings need to be made on the interface card.Pin AssignmentThe ethernet port’s pin assignment is designed for a direct connection, via a RJ45patch cable, to an ethernet Switch. You will need a cross-link cable (“Cross-overCable”) for connection to a PC.IndicatorsThere are four LEDs on the front of the MG+ETH1-1 interface card.
