Available Features Enabled by Administrators198 41-001381-00 REV01 – 06.2013If your phone does not display call destination information, your System Administrator may have disabled this feature.Contact your System Administrator for more information.Indication of Terminated CallsAn Administrator can configure your phone to display a disconnected screen (“Call Terminated”) when the far-end hangsup. An audible busy signal is also heard on the phone. The configuration of this feature can also include the maximumtime interval that the busy signal is audible. Contact your System Administrator for more information.The following is the call terminated screen that displays on the 9480i CT if this feature is enabled on your phone:The following table identifies when a call terminated screen displays on the phone for different scenarios:Notes:When both call diversion and call destination are enabled, the information displays to the phone’s screens in the fol-lowing order:Screen 1 Caller infoScreen 2 Call destinationScreen 3 Call diversionIF THEN1 line active and far-end disconnects, the line in focus:displays disconnected screen.plays busy tone.displays "Call Terminated" message on the screen.the line not in focus:plays busy tone.2 or more lines active, and far-end disconnects, the line in focus:displays disconnected screen.plays busy tone.displays "Call Terminated" message on the screen for 5 seconds.When 5 second times out:the busy tone stopsthe disconnected screen disappears.2 or more lines active, and a line NOT in focus is dis-connected by the far-end, no busy tone playsno disconnected screen displaysno “Call Terminated” message displaysAn incoming call comes in on the line in focus that hasa disconnected screen displaying,the line in focus with no calls on hold:displays a ringing screenthe line in focus WITH calls on hold:flashes its’ Line LEDL1 9480iCall Terminated
