ADEMCO VISTA-128FBP User Manual

Also see for VISTA-128FBP: User guide Programming guide

Contents

ADEMCO VISTA-128FBP User Manual Manual pdf 29 page image

– 29 –Accessing Other Panels (cont’d)NOTES:When performing any of the arming commands, if there are faults in any ofthe partitions, none of the partitions will arm. These faults must be correctedor bypassed before attempting to arm.When performing either a STAY or INSTANT arm command the systemalways arm in mode 1 (see page 36 Arming Perimeter Only for a detailedexplanation of the STAY arming modes.The user cannot execute another panel linking mode. To execute anotherpanel linking mode or to access a different remote panel, the user must firstexit this mode (return to the original control panel).Multi-Panel View ModeTo access the multi-panel view mode, perform the following steps:1. Enter your security code + # + 8 + 72. The keypad displays the following:ALLPANEL 1 2 3 4 5 6 7 8STATUS x x x x x x x xwhere “12345678” are the panel id #s and “xxxxxxxx” is the overall statusof each panel. Possible status indications include:A = Armed Away S = Armed Stay M = Armed MaximumI = Armed Instant R = Ready N = Not ReadyB = Bypassed/Ready ✴ = Alarm T = TroubleF = Fire Alarm P = AC Power Failure L = Low System BatteryC = Comm FailNOTE: See the table that follows for priority of displays.Use the following keys to perform a function in the Multi-Panel View Mode:Press 1 to attempt to disarm all partitions on all panels.Press 2 to attempt to arm AWAY all partitions on all panels.Press 3 to attempt to arm STAY all partitions on all panels.Press 4 to attempt to arm MAXIMUM all partitions on all panels.Press 7 to attempt to arm INSTANT all partitions on all panels.