Menu
ADEMCO LYNX User Manual
Also see for LYNX: Installation instructionsUser guideUser guideQuick start guideSystem manual
                                        | |
Contents
| 
– 4 –6<67(029(59,(:General OperationZones Your system's sensing devices have been assigned to various "zones." For example, thesensing device on your entry/exit door may have been assigned to zone 01, sensingdevices on windows in the master bedroom to zone 02, and so on. These numbers appearon the display when an alarm or trouble condition occurs.Fire ProtectionThe fire protection portion of your security system (if used) is always active and willsound an alarm if a fire condition is detected. Refer to the FIRE ALARM SYSTEM sectionfor important information concerning fire protection, smoke detectors and planningemergency exit routes from the premises.Burglary ProtectionYour system provides two modes of burglary protection: STAY and AWAY. STAYmode protects the perimeter only, allowing you to freely move within inside the premises.AWAY mode protects the entire system. Both modes provide an entry delay time thatallows you to reenter the premises without setting off an alarm. For additional security,you can turn the entry delay off when arming the system by using the NO DELAY key incombination with the desired arming key. The system also allows you to bypass selectedzones before arming the system, if desired. Refer to the BYPASSING PROTECTIONZONES section. The system also provides a CHIME mode, for alerting users to theopening of protected doors and windows while the system is disarmed.You must turn on ("arm") the burglary protection portion of your system before it willsense burglary alarms. To arm the system, enter your security code then press the desiredarming key (AWAY or STAY). Refer to the ARMING THE SYSTEM section for detailedprocedures and information.Security CodesAt the time of installation, you were assigned a personal 4-digit security code. You mustenter the security code when arming and disarming the system, and when performingother system functions. As an additional security feature, other users who do not need toknow your code can be assigned up to 6 different security codes. Refer to the SECURITYCODES section for procedures on adding security codes to the system.Alarms When an alarm occurs, the keypad and sounders will sound, and the keypad will displaythe zone(s) causing the alarm. If your system is connected to a central monitoring station,an alarm message will be sent. To stop the alarm sounding, simply disarm the system. Thezone(s) causing the alarm remain displayed indicating memory of alarm. Refer to theDISARMING THE SYSTEM section for information about clearing the memory of alarmdisplay. |
Related manuals for ADEMCO LYNX
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved