Menu
ADEMCO LYNX User Manual
Also see for LYNX: Installation instructionsUser guideUser guideQuick start guideSystem manual
                                        | |
Contents
| 
– 25 –6<67(0)81&7,216Security CodesGeneral InformationFor additional security, users other than you who do not need to know your code can beassigned different security codes. These secondary users are identified by "user numbers"when their codes are assigned. You can assign up to 6 user codes (2-digit user numbers03-08). Note that the master (primary) user of the system is the only one who can assigncodes to secondary users, and is designated user no. 02; user no. 01 is the installer’s code.All codes can be used interchangeably when performing system functions (a systemarmed with one user's code can be disarmed by another user's code), with the exception ofthe Babysitter Code described below.Babysitter Code (User 07): This code can be used to arm the system, but cannot disarmthe system unless the system was armed with this code. This code is typically assigned tosomeone (such as a babysitter) who needs to arm/disarm the system only at certain times.The Babysitter Code is assigned to User 07.Duress Code (User 08): This feature is intended for use when you are forced to disarmor arm the system under threat. When used, the system will act normally, but can silentlynotify the alarm monitoring company of your situation, if that service has been provided.Duress Code is assigned to User 08.The Duress Code is useful only when the system is connected to an alarm monitoringcompany.To Add/Delete a User or Change a User's CodeChanging the Master CodeFollow the procedure for changing a user's code, but enter User No. 02 and enter the new codetwice.IMPORTANT: Temporary users of the system (e.g., babysitters, cleaning staff) should not beshown how to use any system function they do not need to know, such as bypassing protectionzones for example.Sequential key depressions for all steps in a procedure must be made within 2 seconds ofone another, or else the entire entry is aborted and must be repeated from its beginning.Add a user code: + CODE Key + user number (03-08) + user’s codeMaster CodeDelete a user code: + CODE Key + user number (03-08)Master CodeWait (about 3 seconds) until the keypad beeps once before pressing any other key. Thecode is automatically deleted. |
Related manuals for ADEMCO LYNX
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved