32 Set the origin on your paper. Make sure you have plenty of room to draw the square. Click on the CutProject With icon (or go to Cut Project With>Klic-N-Kut Series): Have the ACS-24HUF draw the square. Then take a ruler and carefully measure the two sides. Click on the Cut Project With icon again, and click on a tiny wrench icon next to the Klic-N-Kut Model menu: A window will open. Click on the Resolution tab and then click on another small wrench icon:Make sure this is lockedH will automatically changeto 8.0, as well, if AspectRatio is lockedTo calibrate in inchesTo calibrate in metricEnter 200mmAfter pressing the Enter key, both W: and H: will be converted to inches, but you can use ametric ruler to measure your drawn square and enter the results in mm, as shown below.Cut Project With iconClick on small wrench icon hereEnter 8.0 and pressthe Enter keyHW
