4 Repair4.3.12. Replacement of motor axis 1-31473HAC030005-001 Revision: -© Copyright 2006 ABB. All rights reserved.Required equipment and ReferencesRemovalC Hex socket head cap screw M6x20 8.8 Gleitmo605D Washer 6,4x12x1,6 Steel A2FE Nitrile rubber O-ring 67,5x3,0F Oil plugG Oil plug (upper oil level hole)H Oil plugI Gear Z1/1-3, 16 cogEquipment Spare part no. NoteStandard Tools Standard toolkit on page196O-ring Spare parts, gear units axis 1- 3 onpage 203AC Motor Spare parts, gear units axis 1- 3 onpage 203Locking liquid Loctite 243ReferencesReplacement of Gearbox Unit 1- 3 on page 141Oil and Grease specification on page 199Action Note1. Remove the gearbox unit 1-3. Described in section Replacement of Gearbox Unit1- 3 on page 141.2. Unscrew the three screws (C)holding the motor.Shown in figure Location on page 1463. Remove the motor.DANGER!Oil will be running out of the motor attachment holewhen removing the motor! The oil can be hot. Takeany necessary measures to collect the oil.ContinuedContinues on next page
