3.3.2 Inspecting Signal lamp (option)Location of signal lampSignal lamp is an option.Located as shown in the figure.AB C Dxx0800000290Signal lampAR3.H1 +, R3.H2 -BR2.CPCR2.CSDRequired equipmentNoteEquipmentFor spare parts no. see Spare parts - Spareparts options in Product manual, spareparts - IRB 2600.Signal lampContent is defined in section Standard toolson page 229.Standard toolkitThese procedures include references to thetools required.Other tools and procedures may be required.See references to these procedures in thestep-by-step instructions below.CAUTIONAlways cut the paint with a knife and grind the paint edge when disassemblingparts. See Cut the paint or surface on the robot before replacing parts on page 117.Inspecting signal lampUse this procedure to inspect the function of the signal lamp.NoteIf the signal lamp is damaged, it shall be replaced!Continues on next page90 Product manual - IRB 24003HAC022031-001 Revision: P© Copyright 2004-2018 ABB. All rights reserved.3 Maintenance3.3.2 Inspecting Signal lamp (option)
