Management Device Configuration 607Configuring a cluster AutomaticallyConfiguringInternal-ExternalInteractionNM Interface for ClusterManagementConfigurationConfiguration Preparation■ The cluster switches are properly connected.■ The internal server is properly connected with the management switch.Configuration ProcedureConfigure VLAN checkon the managementdevice for thecommunication insidea clusterport-tagged management-vlan OptionalExit system view quit —Table 662 Configure a cluster automaticallyOperation Command RemarkEnter system view system-view —Configure a clusterautomaticallyauto-build [ recover ] RequiredThis is to set up a cluster based onyour instructions.Table 661 Configure cluster parameters manually (continued)Operation Command RemarkTable 663 Configure internal-external interactionOperation Command DescriptionEnter system view system-view —Enter cluster view cluster RequiredConfigure an FTP server forthe clusterftp-server ip-address OptionalConfigure a TFTP server forthe clustertftp-server ip-address OptionalConfigure a log host for theclusterlogging-host ip-address OptionalConfigure an SNMP host forthe clustersnmp-host ip-address OptionalTable 664 Configuration procedureStep Command DescriptionEnter system view system-viewEnter cluster view cluster RequiredConfigure the NM interface nm-interface Vlan-interfacevlan_idvlan_id: VLAN IDDisplay information aboutcurrent configurationdisplaycurrent-configurationYou can execute this command inany view.
