458 CHAPTER 40: INFORMATION CENTERn To view the debugging information of some modules on the switch, you need toset the type of the output information to debug when configuring the systeminformation output rules, and use the debugging command to enable debuggingfor the corresponding modules.Enabling system information display on the consoleAfter setting to output system information to the console, you need to enable theassociated display function to display the output information on the console.Enable system informationoutput to the consoleinfo-center console channel{ channel-number |channel-name }OptionalBy default, the switch usesinformation channel 0 tooutput log/debugging/trapinformation to the console.Configure the output rules ofsystem informationinfo-center source {modu-name | default }channel { channel-number |channel-name } [ { log | trap |debug } { level severity |state state } ]*OptionalRefer to Table 345 for thedefault output rules of systeminformation.Set the format of time stampin the output informationinfo-center timestamp { log| trap | debugging } { boot |date | none }OptionalBy default, the time stampformat of the log and trapoutput information is date,and that of the debuggingoutput information is boot.Table 344 Set to output system information to the consoleOperation Command DescriptionTable 345 Default output rules for different output directionsOutputdirectionModulesallowedLOG TRAP DEBUGEnabled/disabledSeverityEnabled/disabled SeverityEnabled/disabled SeverityConsole default (allmodules)Enabled warningsEnabled debuggingEnabled debuggingMonitorterminaldefault (allmodules)Enabled warningsEnabled debuggingEnabled debuggingLog host default (allmodules)Enabled informationalEnabled debuggingDisabled debuggingTrap buffer default (allmodules)Disabled informationalEnabled warnings Disabled debuggingLog buffer default (allmodules)Enabled warningsDisabled debuggingDisabled debuggingSNMP NMS default (allmodules)Disabled debuggingEnabled warnings Disabled debuggingTable 346 Enable the system information display on the console:Operation Command DescriptionEnable thedebugging/log/trapinformation terminal displayfunctionterminal monitor OptionalEnabled by default.
