456 CHAPTER 40: INFORMATION CENTERBetween "module" and "level" is a "/".Level (Severity)System information can be divided into eight levels based on its severity, from 1 to8. Refer to Table 338 for definition and description of these severity levels. Notethat there is a forward slash "/" between the level (severity) and digest fields.DigestThe digest field is a string of up to 32 characters, outlining the system information.Note that there is a colon between the digest and content fields.ContentThis field provides the content of the system information.n The above section describes the log information format sent to a log host by aswitch. Some log host software will resolve the received information as well as itsformat, so that you may see the log format displayed on the log host is differentfrom the one described in this manual.Information CenterConfigurationIntroduction to theInformation CenterConfiguration TasksConfiguringSynchronousInformation OutputSynchronous information output refers to the feature that if the systeminformation such as log, trap, or debugging information is output when the user isinputting commands, the command line prompt (in command editing mode aprompt, or a [Y/N] string in interaction mode) and the input information areechoed after the output.This feature is used in the case that your input is interrupted by a large amount ofsystem output. With this feature enabled, the system echoes your previous inputand you can continue your operations from where you were stopped.Table 341 Information center configuration tasksTask Remarks“Configuring Synchronous Information Output” on page 456 Optional“Displaying the Time Stamp with the UTC Time Zone” on page 457“Setting to Output System Information to the Console” on page 457 Optional“Setting to Output System Information to a Monitor Terminal” onpage 459Optional“Setting to Output System Information to a Log Host” on page 460 Optional“Setting to Output System Information to the Trap Buffer” onpage 461Optional“Setting to Output System Information to the Log Buffer” onpage 461Optional“Setting to Output System Information to the SNMP NMS” onpage 462Optional
