Information Center Configuration 459n Make sure that the debugging/log/trap information terminal display function isenabled (use the terminal monitor command) before you enable thecorresponding terminal display function by using the terminal debugging,terminal logging, or terminal trapping command.Setting to OutputSystem Information to aMonitor TerminalSystem information can also be output to a monitor terminal, which is a userterminal that has login connections through the AUX, VTY, or TTY user interface.Setting to output system information to a monitor terminaln ■ When there are multiple Telnet users or dumb terminal users, they share someconfiguration parameters including module filter, language and severity levelthreshold. In this case, change to any such parameter made by one user willalso be reflected on all other user terminals.■ To view debugging information of specific modules, you need to set theinformation type as debug when setting the system information output rules,Enable debugginginformation terminal displayfunctionterminal debugging OptionalDisabled by default.Enable log informationterminal display functionterminal logging OptionalEnabled by default.Enable trap informationterminal display functionterminal trapping OptionalEnabled by default.Table 346 Enable the system information display on the console:Operation Command DescriptionTable 347 Set to output system information to a monitor terminalOperation Command DescriptionEnter system view system-view -Enable the information center info-center enable OptionalEnabled by default.Enable system informationoutput to Telnet terminal ordumb terminalinfo-center monitorchannel { channel-number |channel-name }OptionalBy default, a switch outputslog/debugging/trapinformation to a user terminalthrough information channel1.Configure the output rules ofsystem informationinfo-center source {modu-name | default }channel { channel-number |channel-name } [ { log | trap |debug } { level severity |state state } ]*OptionalRefer to Table 345 for thedefault output rules of systeminformation.Set the format of time stampin the output informationinfo-center timestamp { log| trap | debugging } { boot |date | none }OptionalBy default, the time stampformat of the log and trapoutput information is date,and that of the debuggingoutput information is boot.
