Information Center Configuration 457n ■ If the system information is output before you input any information followingthe current command line prompt, the system does not echo any commandline prompt after the system information output.■ In the interaction mode, you are prompted for some information input. If theinput is interrupted by system output, no system prompt (except the Y/N string)will be echoed after the output, but your input will be displayed in a new line.Displaying the TimeStamp with the UTCTime ZoneTo add UTC time zone to the time stamp in the information center outputinformation, you must:■ Set the local time zone■ Set the time stamp format in the output direction of the information center todate■ Configure to add the UTC time zone to the output informationSetting to OutputSystem Information tothe ConsoleSetting to output system information to the consoleTable 342 Configure synchronous information outputOperation Command DescriptionEnter system view system-view -Enable synchronousinformation outputinfo-center synchronous RequiredDisabled by defaultTable 343 Configure to display time stamp with the UTC time zoneOperation Command DescriptionSet the time zone for thesystemclock timezone zone-name {add | minus } timeRequiredBy default, UTC time zone isset for the system.Enter system view system-view -Set the timestamp formatin the outputdirection oftheinformationcenter to dateLog hostdirectioninfo-center timestamploghost dateRequiredUse either commandNon loghostdirectioninfo-center timestamp { log |trap | debugging } dateSet to display the UTCtime zone in the outputinformation of theinformation centerinfo-center timestamp utc RequiredBy default, no UTC time zoneis displayed in the outputinformationTable 344 Set to output system information to the consoleOperation Command DescriptionEnter system view system-view -Enable the information center info-center enable OptionalEnabled by default.
