90 CHAPTER 4: CONFIGURING AND USING EME OPTIONSSetting the Password By default, the EME has no password. The first time that you log in, youpress Enter at the Password: prompt. To set a password for the defaultlog in username, use the set login password command.Setting a password for the default login name makes the system moresecure. Without a password, other users can log in with Administeraccess and change system configuration settings.Choose a password that you can remember. If you forget or lose theAdminister password, you cannot log in and perform Administer-levelfunctions. See “Resetting the EME to Default Values” on page 105 forinformation about how to recover system defaults if you forget or losethe Administer password.Example:1 Enter the set login password command.CB9000> set login password2 Enter the password at the prompt.Enter Login password:3 At the next prompt, reenter the password.Verify - re-enter password:Login successfully entered.Adding New Users You can configure up to 10 user logins, with access rights as describedpreviously in this chapter.To add a new user, you must have Administer access.To add a new user:1 Log in using an Administer name and password.2 At the prompt, enter:set login administer Where is the type of user that you are adding:administer, write, or readThe system prompts you for your password (to confirm your right to setnew passwords) as follows:Enter current session password for user “admin”:{enterpassword}3 Enter your password.
