48 XVR16*4th Generation Intel® Core™ i7 Based Rugged VME Single Board Computer Publication No. 500-9300007876-000 Rev. C.05.3.4 PMC2 Connectors (J21, J22, J23, J24)PMC2 is available on the XVR16 when the PMC2/XMC2 is chosen as an option forthe board ((i.e. onboard hard drive is not chosen as an option). The PMC2 is in thenon-edge slot. The PCI signaling voltage is fixed to 3.3 V.The following tables list the pin assignments of the PMC2 connectors. The PMC2slot is 64 bit, PCI-X 133 MHz capable, and works with a PCIe-PCI bridge (PericomPI7C9X130). The PCI bridge and PMC2-bus is disabled when the PMC card is notinstalled or an XMC card is installed at this slot. The PMC disabling can beoverruled by UEFI Firmware Setup adjustments.LINKSee the User Manual for AMI UEFI Firmware Setup www.ami.com.The PMC is electrically and mechanically compliant to the specification IEEE 1386and 1386.1 with enhancements of the Processor PMC Standard VITA 32-2003.These enhancements provide pins for a second device; (IDSELB and REQB/GNTB) but they do not support a monarch PMC card.PMC1IO_61 61 62 PMC1IO_62PMC1IO_63 63 64 PMC1IO_64Table 5-11 PMC1 I/O Connector Pin Assignments (J14) (Continued)Signal Pin Pin Signal
