42 XVR16*4th Generation Intel® Core™ i7 Based Rugged VME Single Board Computer Publication No. 500-9300007876-000 Rev. C.05.2.7 eSATA Interface, Optional (J32)The J32 connector is an optional eSATA connector capable of GEN3 signaling. TheeSATA connector is available only when the XMC/PMC site 2 is not chosen as anoption.Figure 5-9 eSATA Front Panel Port (J32)Table 5-7 SATAxx/eSATA5.3 Onboard Connectors5.3.1 PMC I/O OptionsThere are specific versions of PMC plug-on modules which require specific pinassignments on the VME connectors to be able to use the PMC I/O options and toavoid damage to the XVR16.See Mezzanine Sites.5.3.2 PMC1 Connectors (J11, J12, J13, J14)The following tables list the pin assignments of the onboard PMC1 connectors(J11, J12, J13, J14). The PMC1 slot is 64-bit, up to PCI-X 133 MHz capable andworks with a PCIe-PCI bridge (Pericom PI7C9X130). The PCI bridge and PMC1-bus are disabled when a PMC card is not installed or an XMC card isinstalled at this slot. PMC disabling can be overruled by UEFI Firmware Setupadjustments. The PCI Signaling voltage is fixed at +3.3 V.LINKSee the User Manual for AMI UEFI Firmware Setup. www.ami.com.The PMC is electrically and mechanically compliant to specification IEEE 1386and 1386.1 with enhancements of the Processor PMC Standard VITA 32-2003.These enhancements provide pins for a secondary agent; (IDSELB and REQB/GNTB) but do not support a monarch PMC card.Pin Name2 SATA_TX+3 SATA_TX-5 SATA_RX-6 SATA_RX+1, 4, 7 GND7 1
