116 XVR16*4th Generation Intel® Core™ i7 Based Rugged VME Single Board Computer Publication No. 500-9300007876-000 Rev. C.0A • Transition ModulesA.1 VTM26 Transition ModuleThis section describes the VTM26 Transition Module, compatible with the XVR16and used for easy connection of I/O signals to standard connectors. Please refer toFigure A-1 for the location of available interfaces.Figure A-1 VTM26 Transition ModuleA.1.1 VGA InterfacesVGA1 Interface(P4100)The analog signals of VGA1 are available in any XVR16 board version. TheVTM26 provides these signals at a 15-pin SUB-D connector. The connector isavailable only if a hard-disk is not mounted. The RGB signals are terminated with75 Ohm resistors at the transition module.(P4100)VGA1VGA2COM2COM1DVI1/2PWRP2P0USBUSB0USB1eSATA1SATA3SATA4 ETH3ETH41111111111A1B1C1D1Z17 7CCAASATA5Onboard HDSPDIFAudioOutJ2000(P7201)(P2200)(P1751)(P1720) (P1731)(P5300)(P5400)(P1601)(P7101)(P2201)(P2002)GPIO(P2000)COM2PMC1 PMC2MISC(GPIO/HW_WP#)SATA2U1 Audiosignalling11Connectors highlighted in Green are notloaded when the Hard Drive is loadedLine inLine outCD in(P4000)(S2000)(P2100)(P2901)(P4300)(P1750)(P1740)(U1)
